PRT CTRL Integrated Controller Reference Manual

SV001 Area Grp
None
Use the [1] and [3] keys to scroll the area group selection and press [ENTER] to select the
area group displayed. For more information about the list control data entry refer to the
section List Control Data Entry on Page 406.
Reporting Table
With the size of the protégé system the maximum reporting points available in the Contact ID
format is easily exceeded, to allow flexibility a reporting table has been created to allow
information to be sent using pre-defined zone numbers or values. There are 2 predefined
configurations for the reporting tables and 8 custom tables that can be configured for use by
any of the services. For information on the custom tables refer to the Table Configuration
section on Page 359.
SV001 Reporting
table: 000
To modify the dialing attempts (000 to 255), use the keypad as explained in section Entering
Decimal Numbers on Page 405 and press [ENTER].
Dialling Attempts
The dialling attempts determine how many times the dialler will attempt to dial a number
before failure. This setting will be overridden by the modem configuration dependent on the
country of installation. For UL and ULC installations this value can not be set above 8 and will
be internally restricted if a value is programmed above this value. The dialling attempts
operates in conjunction with the dialling delay setting.
SV001 Dialling
attempts: 008
To modify the dialing attempts (000 to 255, a setting of 000 will result in the default of 8
attempts being used), use the keypad as explained in section Entering Decimal Numbers on
Page 405 and press [ENTER].
Port Open Attempts
The port open attempts determine how many times the service will wait for the modem to
become available if another service is already using modem for communication. This operates
in conjunction with the port open time settings.
SV001 Port open
attempts: 008
To modify the port open attempts (000 to 255, a setting of 000 will result in the default of 8
port attempts being used), use the keypad as explained in section Entering Decimal Numbers
on Page 405 and press [ENTER].
Report Count
The report count if set to a value other than 000 will restrict the service from sending more
than the programmed number of reports to the monitoring station. When using multiple
207 Protégé Integrated System Controller Reference Manual