PRT CTRL Integrated Controller Reference Manual

Option 1 – Service Used For Back Up Operation
Enabled the service will NOT report messages and alarms unless it is
started by another service that has failed. It will then start reporting
messages immediately from the point that the service that started it failed
to report and then return operation to the service that started. This cycle
will continue until the service that failed operates normally.
When using a service in Back Up mode the service should be
programmed with the same area group and account code as the
service it is backing up. In some cases it may be desirable to
program a different account code for the back up service. Consult
with your Monitoring Station Operator to ensure you correctly
configure the back up service.
Disabled the dialer will operate as a normal service and report alarms as
programmed.
Option 2, 3, 4, 5, 6, 7 and 8 - Reserved
Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
Miscellaneous Options
The miscellaneous options allow you to program special functions and features for the contact
ID service.
SV001 Misc
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 - Log Modem Service Events
Enabled the service will provide step by step event information showing the
call progression and detailed logging information. This option can be turned
on for diagnostic purposes but should not be enabled as large volumes of
events are stored.
Disabled the dialer will not log events.
Option 2, 3, 4, 5, 6, 7 and 8 - Reserved
Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
Area Group
An area group will define which areas this service will process when a reportable event is
generated. An area group of None (default) will result in all areas being sent with the service.
Protégé Integrated System Controller Reference Manual
206