PRT CTRL Integrated Controller Reference Manual

Option 2 - DTMF Tone / Pulse Dialing
Enabled the dialer will use pulse dialing to dial out.
Disabled the dialer will always use DTMF to dial except when Option 3 has
been enabled.
Option 3 - Switch Dialing To Pulse On 5 th Atempt
Enabled the dialer will switch to the pulse dialing format on the 5 th attempt
to dial the selected phone number.
Disabled the dialer will always use DTMF to dial.
Option 4 - Switch To Second Phone Line On Failure
Enabled the dialer will switch the secondary phone line over and use this to
dial if the first phone line fails or fails to communicate.
Disabled the dialer will use the first phone line.
Option 5 - PABX Requires Pause
Enabled the dialer will insert a pause of 2.5 seconds after the PABX
telephone number is dialled.
Disabled the dialer will dial the numbers with a standard DTMF inter digit
delay.
Option 6, 7 and 8 - Reserved
Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
Events Options
The events options allow you to filter the type of events that this contact ID service will send
to the monitoring station.
SV001 Events
[123456--]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 - Report Opens
Enabled the service will report opens (Disarming) for the areas that are part
of the area group assigned. An area group of none will mean ALL areas will
be sent using this service.
Disabled the dialer will not report opens.
Option 2 - Report Closes
Protégé Integrated System Controller Reference Manual
204