PRT CTRL Integrated Controller Reference Manual

Use the [1] and [3] keys to scroll the available phone numbers and press [ENTER] to select
the phone number displayed. To program a phone number select [MENU, 4, 7, 2]. For more
information about the list control data entry refer to the section List Control Data Entry on
Page 406.
Phone Number Two
The secondary phone number will be dialed by the contact ID service if a connection with the
central station can not be made on the primary phone number. This may be dialled after the
total number of attempts is reached on the primary or sequential until the total number of
attempts is reached for the primary and secondary numbers. The sequence of telephone
number dialling is limited by the number of dialling attempts and the method of dialling that is
configured (alternate or sequential).
SV001 Phone 2
None
Use the [1] and [3] keys to scroll the available phone numbers and press [ENTER] to select
the phone number displayed. To program a phone number select [MENU, 4, 7, 2]. For more
information about the list control data entry refer to the section List Control Data Entry on
Page 406.
Backup Phone Number
The backup phone number will be dialed by the contact ID service if a connection with the
central station can not be made on either the primary or secondary phone number. This will
be dialled after the total number of attempts is reached on the primary and secondary
numbers. The backup number will be dialled for the configured number of dialling attempts
programmed for the service. For information on the dialing sequence refer to the section
sequential dialing attemps on page XX and alternate dialling attempts on page XX.
SV001 Backup
None
Use the [1] and [3] keys to scroll the available phone numbers and press [ENTER] to select
the phone number displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Dial Options
The dial options configure the service as to how it is meant to dial when a reportable event
has been generated.
SV001 Dial
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 - Alternate Dialing Configuration
Enabled the dialer will use the alternate dialing method, refer to the
alternate dialing section on page XX.
Disabled the dialer will use sequential dialing method, refer to the
sequential dialing section on page XX.
203 Protégé Integrated System Controller Reference Manual