PRT CTRL Integrated Controller Reference Manual

Service Mode
The service mode determines how this service operates with the system controller. By default
a service is set to start with the operating system. Setting a service to Start With The
Operating System (Start With O/S) allows the service to operate automatically, if the system
controller is reset or restarts the service will automatically restart with the operating system.
To only start and stop the service manually select the manual option.
SV001 Ser Mode
Start with O/S
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select
the operating mode displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Contact ID Client Code
The contact ID client code is used to identify the system to the remote monitoring company
when a report is generated. The client code will accept hexadecimal numbers however this
will be dependent on the ability of the receiver and should be verified before configuration.
SV001 Client
code: 0000
Type the appropriate 4 digit client code, after each digit you must press [] and [] to move
to the next digit. When the desired client code is entered, press [ENTER] to save the
programmed setting and move to the next screen. For more information about hexadecimal
data entry refer to the section Hexadecimal Data Entry on Page 406.
PABX Phone Number
The PABX phone number is dialed to gain an outside line if the system is connected to a
internal phone extension. The PABX phone number can also be programmed with a schedule
in the case that between certain times the phone line is directly connected with an outside
line.
SV001 PABX
None
Use the [1] and [3] keys to scroll the available phone numbers and press [ENTER] to select
the phone number displayed. To program a phone number select [MENU, 4, 7, 2]. For more
information about the list control data entry refer to the section List Control Data Entry on
Page 406.
Phone Number One
The primary phone number will be dialed by the contact ID service when it first is initiated to
report an event. The sequence of telephone number dialling is limited by the number of
dialling attempts and the method of dialling that is configured (alternate or sequential).
SV001 Phone 1
None
Protégé Integrated System Controller Reference Manual
202