PRT CTRL Integrated Controller Reference Manual

REPORTING
Introduction
The reporting of messages and control of communication services is done from within the
reporting menu. The reporting menu allows the programming of services for communication
to central station monitoring systems, offsite ModBUS communication receivers, local
computer monitoring using the PRT-SMGT Protégé System Management suite and dial up
communication.
MENU 4, 7
SERVICES
PROGRAMMING
MENU 4, 7, 1
SERVICE
PROGRAMMING
MENU 4, 7, 2
PHONE NUMBER
PROGRAMMING
Figure 12 - Reporting Menu Overview
To go to the reporting menu select [MENU, 4, 7]. You can then select from the menu items
presented or scroll the menu using the [] and [] keys.
Services
To access the communication service programming menu login using a valid installer code
and then select [MENU, 4, 7, 1]. The screen displays “Service to modify” as shown in the
following example.
Service to
modify: SV001
Services are a vital component to the Protégé System and allow many communication and
monitoring functions to be performed. Services are small independent functions within the
protégé that are used to communicate information or perform specialized control functions.
An example of a communication service that is programmed by default for SV001 is the local
PC computer upload service.
When the service appears on the screen, press [ENTER] to program the service. The
maximum number of services that can be programmed is limited by your system’s memory
and configured profile.
Services that dial telephone numbers to report or send information to a remote
location may be limited by a fixed maximum number of dialing attempts. This
configuration limitation only applies in countries that impose a dialing attempts
restriction and only settings below this value are allowed. Please verify with your
Protégé Integrated System Controller Reference Manual
198