PRT CTRL Integrated Controller Reference Manual

GROUP
Introduction
Groups of objects allow you to control multiple objects in the Protégé System. Groups include
PGM and Keypad Groups. To go to the groups sub menu select [MENU, 4, 6]. You can then
select from the PGM Group or Keypad Group menu or scroll the menu using the [] and []
keys.
MENU 4, 6
GROUPS
PROGRAMMING
MENU 4, 6, 1
PGM GROUPS
PROGRAMMING
MENU 4, 6,
KEYPAD GROUP
PROGRAMMING
PGM Group
Figure 11 - Group Menu Overview
To access the PGM group programming login using a valid installer code and then select
[MENU, 4, 6, 2]. The screen displays “PGM Group to modify” as shown in the following
example.
PGM groups allow you to control multiple PGM outputs from one PGM entry point selection in
the Protégé System. When you assign a PGM or a PGM group to a module or an area, for
example, the screen displays the PGM address format by default.
PGM Group to
modify: PG001
When the desired PGM group appears on the screen, press [ENTER] to program the PGM
group. The maximum number of PGM groups that can be programmed is limited by your
system’s memory and configured profile.
To browse the PGM groups by name press [ENTER] when prompted for a PGM group to
modify and then use the [] and [] keys to scroll the available PGM groups by their name.
Selecting a PGM Group to Modify
Each PGM Group is assigned a unique door type number from 001 to 064. Your system will be
limited to specific number of PGM groups that are defined in the selected profile. For
information on profiles refer to the Advanced Programming Section on Page 265.
Protégé Integrated System Controller Reference Manual
192