PRT CTRL Integrated Controller Reference Manual

Floor
Unlock late to open will only operate if the elevator is configured for
destination reporting and a PRT-PX16-DRI is present.
Disabled the floor will follow the floor schedule if programmed.
Option 2 – Validate Schedule Every Minute
Enabled the floor state will be checked against the schedule every minute
and change state accordingly.
Disabled the floor will unlock at the start time of the schedule and lock at
the end time. The floor will not be controlled during this time by the
schedule.
Option 3 – Follow Area Status
Enabled the floor will follow the status of the area. If the area is armed the
floor will lock and if the area is disarmed the floor will unlock.
Disabled the floor will not follow the area status.
Option 4, 5, 6, 7 and 8 - Reserved
Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
Each floor is assigned a unique floor number in the Protégé System. Each elevator can have a
maximum of 128 floors. Floors are given a name that is used when generating events and
reporting information.
Floor to
modify: FL001
To access elevator programming, login using a valid code that has access to the floor
programming menu and then select [MENU, 4, 5, 3]. The screen will then prompt you to
"Select a Floor to modify" requesting that you enter a floor number. Type the appropriate 3-
digit floor number or use the [] and [] keys to scroll the available floors. When the desired
floor number appears on the screen, press [ENTER] to program the selected floor. The
maximum number of floors that can be programmed is limited by your system’s memory and
configured profile.
To browse the floors by name press [ENTER] when prompted for a floor number to modify
and then use the [] and [] keys to scroll the available floors by their name.
Selecting a Floor to Modify
Each floor is assigned a unique door number from 001 to 250. Your system will be limited to
specific number of floors that are defined in the selected profile. For information on profiles
refer to the Advanced Programming Section on Page XX.
Protégé Integrated System Controller Reference Manual
190