PRT CTRL Integrated Controller Reference Manual

Reader Expander
The reader expander selection programs the elevator to send the activation of floor
information and floor selection to the reader expander programmed. You must also set the
port number in the next screen to the appropriate port driving this elevator.
EL001 Reader
None
Use the [1] and [3] keys to scroll the reader expanders that are available and press [ENTER]
to select the expander displayed. For more information about the list control data entry refer
to the section List Control Data Entry on Page 406.
Reader Port
The reader port selection programs the elevator to communicate on this port with the
expander number selected above. You must also set the reader expander number in the
previous screen.
EL001 Port
None
Use the [1] and [3] keys to scroll the reader port and press [ENTER] to select the port
displayed. For more information about the list control data entry refer to the section List
Control Data Entry on Page 406.
Floor Open Time
The floor open time configures the amount of time that a floor will be activated for when it
has been selected or the amount of time the floor relay will be activated for when the user
has presented a card.
EL001 Open
time: 005 secs
To modify the Floor open time (000 to 255 Seconds), use the keypad as explained in section
Entering Decimal Numbers on Page 405 and press [ENTER].
Destination Select Time
The destination select time configures the amount of time that user has to select a floor when
they present their card.
EL001 Select
time: 005 secs
To modify the floor select time (000 to 255 Seconds), use the keypad as explained in section
Entering Decimal Numbers on Page 405 and press [ENTER].
Floor Configuration
Each floor in an elevator can be assigned options, an unlock schedule and an area. These
options configure how the floor will function. You must select the floor to modify for the
elevator that you are programming.
Protégé Integrated System Controller Reference Manual
188