PRT CTRL Integrated Controller Reference Manual

Miscellaneous Options
Miscellaneous options for the door type are used to control the REX and REN operation of the
door. Use these settings to prevent the request to exit and request to enter from operating
when an area is armed or when a function is being processed.
DT001 Misc
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 – Disable REX Request To Exit
Enabled the door will disable the REX (request to exit) operation.
Disabled the door will allow REX (request to exit) operation.
Option 2 – Disable REN Request To Enter
Enabled the door will disable the REN (request to enter) operation.
Disabled the door will allow REN (request to enter) operation.
Option 1, 2, 3, 4, 5, 6, 7 and 8 - Reserved
Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
Elevator
Each elevator is assigned a unique elevator address. Elevators are used for the control of
access by users or to monitor and control floors in a multi storey high rise buildings.
Elevator to
modify: EL001
To access elevator programming, login using a valid code that has access to the elevator
programming menu and then select [MENU, 4, 5, 3]. The screen will then prompt you to
"Select a Elevator to modify" requesting that you enter a elevator number. Type the
appropriate 3-digit elevator number or use the [] and [] keys to scroll the available
elevators. When the desired elevator number appears on the screen, press [ENTER] to
program the selected elevator. The maximum number of elevators that can be programmed is
limited by your system’s memory and configured profile.
To browse the elevators by name press [ENTER] when prompted for a elevator number to
modify and then use the [] and [] keys to scroll the available elevators by their name.
Selecting a Elevator to Modify
Each elevator is assigned a unique door number from 001 to 250. Your system will be limited
to specific number of elevators that are defined in the selected profile. For information on
profiles refer to the Advanced Programming Section on Page XX.
Protégé Integrated System Controller Reference Manual
186