PRT CTRL Integrated Controller Reference Manual

Secondary Door Type
The secondary door type is used in conjunction with the schedule to allow a door to have a
secondary configuration when the schedule that is assigned is invalid. This allows different
modes of control over the method a user access the door. For example between 8am and
12pm the user can be required to access the door with only a card however outside these
hours a card and pin is required.
DT001 Schedule
None
Use the [1] and [3] keys to scroll the secondary door type selection and press [ENTER] to
select the door type displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Reader Entry Operation Mode
The reader entry operation mode determines how an entry reader that is associated with the
door that has this door type assigned will operate. There are four possible modes that can be
set to allow the use of card, card and pin, card or pin and pin only to operate.
DT001 Read In
Card Only
Use the [1] and [3] keys to scroll the reader in modes and press [ENTER] to select the mode
displayed. For more information about the list control data entry refer to the section List
Control Data Entry on Page 406.
Anti Pass Back Entry Operation Mode
The reader anti pass back operation mode determines how an entry reader controls the ability
for a user to pass back their card or details for another person to gain access while they are
already inside a protected area. The Protégé System use's global anti pass back per
controller.
Selecting soft pass back will allow the user entry however it will log an error in the buffer that
a pass back violation has occurred. Selecting hard pass back will prevent the user from
gaining entry and also log an event.
DT001 Pass In
None
Use the [1] and [3] keys to scroll the anti pass back modes and press [ENTER] to select the
mode displayed. For more information about the list control data entry refer to the section
List Control Data Entry on Page 406.
Reader Exit Operation Mode
The reader in operation mode determines how an exit reader that is associated with the door
that has this door type assigned will operate. There are four possible modes that can be set to
allow the use of card, card and pin, card or pin and pin only to operate.
DT001 Read Out
Card Only
Protégé Integrated System Controller Reference Manual
184