PRT CTRL Integrated Controller Reference Manual

Forced Open PGM Pulse ON Time
The forced open PGM pulse on time is used to make the PGM output pulse on and off when
activated. The value entered here must be greater than 0 and is in increments of 100ms. For
example setting 10 will pulse the unit on for 1 second and then off for the programmed time
set in the pulse off section.
DR001 Forced
time: 000 on
To modify the forced open pulse on time (000 to 255 100ms Increments), use the keypad as
explained in section Entering Decimal Numbers on Page 405 and press [ENTER]. Both the on
and off pulse settings must have a value greater than 000 for this feature to operate.
Forced Open PGM Pulse OFF Time
The forced open PGM pulse off time is used to make the PGM output pulse on and off when
activated. The value entered here must be greater than 0 and is in increments of 100ms. For
example setting 10 will pulse the unit off for 1 second and then on for the programmed time
set in the pulse on section.
DR001 Forced
time: 000 off
To modify the forced open pulse off time (000 to 255 100ms Increments), use the keypad as
explained in section Entering Decimal Numbers on Page 405 and press [ENTER]. Both the on
and off pulse settings must have a value greater than 000 for this feature to operate.
Miscellaneous Options
Miscellaneous options for the door include the control of events that are generated and the
function of the door schedule.
DR001 Misc
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 - Check Schedule Each Minute
Enabled the door will revalidate the unlock schedule that it is assigned each
minute. This will prevent the door from being controlled and locked when it
should be unlocked.
This option also prevents schedule and area control from operating
correctly and if enabled will prevent the follow inside and follow
outside area status from operating. Setting this option will allow the
prevent unlock on arming and normal scheduling operations to
occur.
Disabled the schedule will operate normally and be checked at the start and
end times.
Option 2 - Door Open Event When On Schedule
Protégé Integrated System Controller Reference Manual
178