PRT CTRL Integrated Controller Reference Manual

number of doors that can be programmed is limited by your system’s memory and configured
profile.
To browse the doors by name press [ENTER] when prompted for a door number to modify
and then use the [] and [] keys to scroll the available doors by their name.
Selecting a Door to Modify
Each door is assigned a unique door number from 001 to 250. Your system will be limited to
specific number of doors that are defined in the selected profile. For information on profiles
refer to the Advanced Programming Section on Page XX.
Select door to
modify: DR001
Type the appropriate 3-digit door number or use the [] and [] keys to scroll the available
door numbers. When the desired door number appears on the screen, press [ENTER] to
program the selected door number. The maximum number of doors that can be programmed
is limited by your system’s memory and configured profile.
Door Name
If the selected door has a name associated (some doors do not have a name associated with
them) the name programming screen will be shown.
DR001 Name
*Door 001
To scroll doors by name use the [] and [] keys. To modify or enter a new name for the
selected door use the keypad as explained in section Entering Text and Names on Page 406
and press [ENTER].
By default the door name will be prefixed by an '*' this indicates that the name is an editable
name in the system. Some doors do not have names, this is limited by the system memory
and the profile configured.
Door Type Selection
The door type selection allows the door to function in different modes. These modes require
the user to present specific credentials for example a card, card and pin, card or pin and pin
only. By using a door type these can be scheduled dependent on the time of day allowing
different security credentials to be used.
DR001 Type
Card Only
Use the [1] and [3] keys to scroll the door type selection and press [ENTER] to select the
door type displayed. For more information about the list control data entry refer to the section
List Control Data Entry on Page 406.
Slave Door
The slave door will follow the primary door (this door) when it unlocks and locks. This can be
used to operate a second door that is required to gain access only when a specific entry path
is used. For example to gain access to a door a you must access door b.
173 Protégé Integrated System Controller Reference Manual