PRT CTRL Integrated Controller Reference Manual

ACCESS CONTROL
Introduction
To access the access programming menu, login using a valid code that has access to the
access programming menu and then select [MENU, 5]. The Access menu enables you to set
up and program all the doors in your system. This includes setting areas outside and inside
the door as well as special options for each door.
MENU 4, 5
ACCESS
PROGRAMMING
MENU 4, 5, 1
DOOR
PROGRAMMING
MENU 4, 5, 2
DOOR TYPE
PROGRAMMING
MENU 4, 5, 3
ELEVATOR
PROGRAMMING
MENU 4, 5, 4
FLOOR
PROGRAMMING
Door
Figure 10 - Access Control Menu Overview
To allow certain users access to a door the users access level must have a door group
assigned. To create or modify door groups refer to the door group programming section.
Doors can also be interlocked preventing other users from gaining access to the door if
another door is open or not locked.
Each door is assigned a unique door address. Doors are used for the control of access by
users or to monitor and control doors to allow the flow of people in to an area.
Select door to
modify: DR001
To access door programming, login using a valid code that has access to the door
programming menu and then select [MENU, 5, 1]. The screen will then prompt you to "Select
a door to modify" requesting that you enter a door number. Type the appropriate 3-digit door
number or use the [] and [] keys to scroll the available doors. When the desired door
number appears on the screen, press [ENTER] to program the selected door. The maximum
Protégé Integrated System Controller Reference Manual
172