PRT CTRL Integrated Controller Reference Manual

Enabled the area will not activate the Exit PGM when the area is stay
armed.
Disabled the area will activate the Exit PGM if programmed when the area is
stay armed.
Option 4 – Clear Alarm Memory on Arm
Enabled the area clear all alarm memory when the area is armed.
Disabled the area will arm normally.
Option 5 – Early/Late Arm Report
Enabled the area will generate Early to Arm and Late to Arm reportable
events accordining to the normal operating schedule (see above).
Disabled the area will not generate these events.
Option 6 – Early/Late Disarm Report
Enabled the area will generate Early to Disarm and Late to Disarm
reportable events accordining to the normal operating schedule (see
above).
Disabled the area will not generate these events.
Option 7 and 8 – Reserved
Area Squawk Options
The squawk options determine if the Bell PGM is activated with one short squawk when the
system is armed and two short squawks when the system is disarmed.
AR001 Special
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 – Bell Squawk Arm Start
Enabled the area will squawk the Bell PGM when the arming process starts.
Disabled the area will not squawk.
Option 2 – Bell Squawk Arm Complete
Enabled the area will squawk the Bell PGM when the arming process is
complete and the exit delay has ended.
Disabled the area will not squawk.
Option 3 – Bell Squawk Arm Unattended
Enabled the area will only squawk the Bell PGM when the area is armed by
an unattened arming, e.g. Card Reader, Remote Service, Key Switch, Door,
Protégé Integrated System Controller Reference Manual
170