PRT CTRL Integrated Controller Reference Manual

Option 6 - Banking Vault Dual Control Area
Enabled the area will require that two users control this area when enabled
as a vault control area. This feature will not function unless the area has
option 5 enabled.
Disabled the area will require only one code to control the vault control
functions.
Option 7 - Prevent Arming if Count is Not Zero
Enabled the area will be prevented from arming if the count value for the
area is greater than 0.
Disabled the area will arm regardless of the count value.
Option 8 - Validate Schedule Each Minute
Enabled the area will verify that the programmed schedule has not changed
or the area has not be disarmed when it should be armed. This will occur
every one minute period.
Disabled the area does not check the schedule each minute. If the schedule
is programmed the schedule is validated when the start time is reached and
when the end time is reached and does not take in to account the control of
the area outside these times.
It is recommended not to enable/disable or modify the settings of reserved options.
Area Special Options
The special options include a number of specific options that may be required in special
circumstances.
AR001 Special
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 – Defer Automatic Arming
Enabled the area will begin a defer arming cycle prior to starting to arm the
area when the area is set to automatically arm on schedule.
Disabled the area will arm normally.
Option 2 – Force Arm Card Reader
Enabled the area will force arm the area when the arming process is started
by a card reader.
Disabled the area will arm normally.
Option 3 – Disable Exit PGM on Stay
169 Protégé Integrated System Controller Reference Manual