PRT CTRL Integrated Controller Reference Manual

Armed PGM Pulse ON Time
The armed PGM pulse on time is used to make the PGM output pulse on and off when
activated. The value entered here must be greater than 0 and is in increments of 100ms. For
example setting 10 will pulse the unit on for 1 second and then off for the programmed time
set in the pulse off section.
AR001 Armed
time: 000 on
To modify the pulse on time (000 to 255 100ms Increments), use the keypad as explained in
section Entering Decimal Numbers on Page 405 and press [ENTER]. Both the on and off pulse
settings must have a value greater than 000 for this feature to operate.
Armed PGM Pulse OFF Time
The armed PGM pulse off time is used to make the PGM output pulse on and off when
activated. The value entered here must be greater than 0 and is in increments of 100ms. For
example setting 10 will pulse the unit off for 1 second and then on for the programmed time
set in the pulse on section.
AR001 Armed
time: 000 off
To modify the pulse on time (000 to 255 100ms Increments), use the keypad as explained in
section Entering Decimal Numbers on Page 405 and press [ENTER]. Both the on and off pulse
settings must have a value greater than 000 for the pulse output to operate.
Disarmed PGM or PGM Group
You can assign a PGM or PGM group to activate whenever the area completes the disarming
cycle. The disarmed PGM or PGM Group will be deactivated when the area completes the
arming cycle. Use this to drive local indicators on keypads, card readers and relays for
signalling that the system is disarmed and can be entered. This can also be used for
interlocking non reader controlled doors to prevent entry to areas if the area is armed. Use
this output in conjunction with user area's to control multiple storage lockers or storage
facilities.
AR001 Disarmed
pgm: --000:00
To modify the Disarmed PGM or PGM Group, use the settings as explained in section Entering
PGM and PGM Groups on Page 410.
Disarmed PGM Pulse ON Time
The disarmed PGM pulse on time is used to make the PGM output pulse on and off when
activated. The value entered here must be greater than 0 and is in increments of 100ms. For
example setting 10 will pulse the unit on for 1 second and then off for the programmed time
set in the pulse off section.
AR001 Disarmed
time: 000 on
Protégé Integrated System Controller Reference Manual
158