PRT CTRL Integrated Controller Reference Manual

Intelligent False Alarm Prevention Time
Setting an intelligent false alarm prevention time allows the area to process alarms using
smart alarm verification. For an alarm to occur in the area it will require that the same zone
generate more than one alarm in a time programmed or that any other zone that is not
assigned the intelligent false alarm prevention time generates an alarm.
AR001 Intel zone
time: 000 secs
To enter an intelligent false alarm prevention time (000 to 250 seconds), use the keypad as
explained in section Entering Decimal Numbers on Page 405 and press [ENTER]. Setting the
intelligent false alarm prevention time to a value of 000 will result in any intelligent false
alarm prevention zone from activating normally.
Re-Arm Delay
Setting the re-arm delay will result in the area automatically re-arming after the re-arm timer
has elapsed. This should be programmed for area's used to monitor and control system
functions that should not be disarmed.
This is also used to control vault and automatic teller machines when using the banking area
functions to prevent an area from being disarmed for longer than a the time programmed.
AR001 Re-arm on
time: 030 mins
To enter a re-arm delay time (000 to 250 minutes), use the keypad as explained in section
Entering Decimal Numbers on Page 405 and press [ENTER]. For the re-arm timer to operate
the re-arm option must be enabled.
Arming/Disarming Schedule
The arming and disarming schedule is programmed so that an area will be armed and
disarmed according to a schedule that is assigned.
The area will be disarmed at the start time and armed at the end time of the schedule.
In the case that an area only requires to be disarmed program the start time with the time
that is required to disarm and the end time of the schedule with --:--. This will mean the area
will automatically disarm at the start time for the programmed days in the period.
Do the same if the area requires to be armed only on schedule by programming the end
period with the required time to arm and set the start time to --:--.
AR001 Schedule
None
Use the [1] and [3] keys to scroll the schedule selection and press [ENTER] to select the
schedule displayed. For more information about the list control data entry refer to the section
List Control Data Entry on Page 406.
Protégé Integrated System Controller Reference Manual
152