PRT CTRL Integrated Controller Reference Manual

CP001:01 Misc
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 - Log PGM Event
Enabled the PGM will generate an event whenever it is activate or
deactivated.
The PGM will still perform all functions that are programmed if this is not
enabled. When using PGM's as automation control outputs it is
recommended to disable the event logging option to reduce the impact on
the event log buffer.
Disabled the PGM will not log an event.
Option 2 - Verify Schedule State
When enabled the PGM will re verify the schedule that is programmed every
60 seconds. If the PGM is meant to be activated but is in a deactivated state
the system will activate the PGM.
Disabled the PGM will only activate at the start time and the end time of the
programmed schedule.
Option 3 - Change PGM State at Panel Reset
Enabled the PGM will be set to the state that is selected by option four when
the panel is reset or powers up for the first time. By default this option is
enabled and all PGM's will be set to the deactivated state.
Disabled the PGM state will not be changed from when the panel was reset
or powered down.
Option 4 - PGM State Setting
Enabled the PGM will be activated if option three is enabled.
Disabled the PGM will be deactivated if option three is enabled.
Option 5 - Inverted Operation
Enabled the PGM will operate inverted. Deactivation will result in the PGM
being activated and activation will result in the PGM being deactivated.
Disabled the PGM will operate normally.
Option 6 - Activate On Module Power Up and Reset
When enabled the PGM will activate when the module powers up, this will
be overridden by the current state that is held in the controller.
Please note these options are different from the activation and
deactivation settings in the miscellaneous section as they relate to
Protégé Integrated System Controller Reference Manual
148