PRT CTRL Integrated Controller Reference Manual

Option 1 – Always Log Zone Event
Enabled the zone will always log an event when it changes state. Using this
feature can allow a zone to have one area armed permanently for
automation events without it creating events in the event buffer, but when
the alarm area is armed events can still be generated. Note that the zone
option “Log Zone Events” will override this option.
Disabled the zone not generate events.
Option 2 to 8 - Reserved
Reserved.
Reserved.
Reporting Code
Each zone type has a default reporting code already assigned which determines the code that
is sent to the central station when an alarm is generated refer to the Contact ID Codes table
on Page 381. However, it is possible to change the reporting code of the zones to which this
zone type is assigned. This is used when using special reporting formats for example ModBUS
Remote uses this to identify special zone points to the remote Protégé System Controller.
ZT001 Report
code: 255
To enter a reporting code (000 to 254), use the keypad as explained in section Entering
Decimal Numbers on Page 405 and press [ENTER]. By default the Zone Type Reporting Code
is set to 255. Setting a value of 255 uses the default reporting code for the zone assigned.
Control PGM or PGM Group
You can assign a PGM or PGM group to activate whenever a zone type process's an alarm or
restore for a zone. The zone type must have the control PGM options set in the PGM options.
ZT001 Control
pgm: --000:00
To modify the PGM or PGM Group, use the settings as explained in section Entering PGM and
PGM Groups on Page 410.
Control PGM Activation Time
You can override the programmed activation time for a PGM by setting an activation time in
the zone type.
ZT001 PGM on
time: 00000 secs
To modify the PGM or PGM Group, use the settings as explained in section Entering PGM and
PGM Groups on Page 410.
Protégé Integrated System Controller Reference Manual
144