PRT CTRL Integrated Controller Reference Manual

Enabled the zone type will allow this zone to generate alarms during the exit
delay however it will generate an alarm if the alarm condition occurs outside
the exit delay period.
Use this feature to prevent 'Sitters' from re-entering a building that is
assumed to be secure during a long arming process.
Disabled the zone type operates normally.
Option 6 - Shorten Exit Delay Timer On Restore
Enabled the zone type will shorten the exit delay timer on an area to five
seconds when the zone restores.
Use this feature to reduce the arming time of an area.
Disabled the zone type operates normally.
Option 7 - 24HR Alarm
Enabled the zone type will generate a 24HR alarm if the zone generates an
alarm. The area state will not affect the generation of this alarm.
Disabled the zone type operates normally.
Option 8 - Fire Alarm
Enabled the zone type will generate a fire alarm when it is activated. This
zone type will also operate similar to the 24HR Alarm option.
Most smoke detectors use a normally open contact so any zone that is
assigned this option must have the inverted state option selected and the
EOL resistors option enabled.
Disabled the zone type operates normally.
It is recommended not to enable/disable or modify the settings of reserved options.
Zone Type Report Options
Reporting options for the zone type configure the operation of the zone type when reporting
to a communication service and includes options for various other zone type options.
ZT001 Report
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 - Report Alarm
Enabled the zone type will generate a reportable alarm message.
Disabled the zone type does not generate a reportable alarm message.
Option 2 - Report Tamper
137 Protégé Integrated System Controller Reference Manual