PRT CTRL Integrated Controller Reference Manual

Use the [1] and [3] keys to scroll the available zone types that can be assigned to the zone.
For more information about the list control data entry refer to the section List Control Data
Entry on Page 406.
Control PGM or PGM Group
You can assign a PGM or PGM group to activate whenever a zone type process’s the zone with
the activate zone PGM options enabled. The zone type must have the appropriate zone control
PGM options set in the PGM options. A PGM can be assigned to the zone type and to the zone
allowing many to one and one to many configurations.
CP001:01 Control
pgm: --000:00
To modify the PGM or PGM Group, use the settings as explained in section Entering PGM and
PGM Groups on Page 410.
To activate the Control PGM in a zone the zone type used to process the zone must
have the zone control options set. The zone control options are different from the
Zone Type control options.
Automation Control Point
An automation control point allows this zone to control an automation point in response to a
zone type configuration. The automation point can be programmed to activate when when the
zone opens or closes. An automation point can be assigned many different functions such as
gardening irrigation, lighting circuits, CBus Circuits and any PGM Output. You must configure
the appropriate options to trigger the Automation point in the Zone Type. An automation
point can also be triggered from a zone type allowing many too one and one to many
configurations.
ZT001 Automate
None
Use the [1] and [3] keys to scroll the available automation points and press [ENTER] to
select the automation point displayed. For more information about the list control data entry
refer to the section List Control Data Entry on Page 406.
Zone Alarm Zone Speed
This determines how long a zone must be open for before an alarm event will be generated.
This can be set from 0 seconds up to 1 hour. If the Alarm Zone Speed is set at 0 seconds,
the Restore Zone Speed can not be set below 100ms.
CP001:01 Alarm
500 msec
Use the [1] and [3] keys to scroll the available areas that can be assigned to the zone. For
more information about the list control data entry refer to the section List Control Data Entry
on Page 406.
127 Protégé Integrated System Controller Reference Manual