PRT CTRL Integrated Controller Reference Manual

Zone Special Options
Special options for the zone include the configuration of special bypass and wiring settings for
the zone.
CP001:01 Special
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 - Tamper Bypass Allowed
Enabled the zone will bypass the tamper monitoring of the zone at the time
the zone is bypassed.
Disabled the zone will only bypass the alarm states and a tamper alarm or
short will generate a tamper alarm.
Option 2 - No Bypass When Area Armed
When enabled the zone will be prevented from being bypassed if it is
already assigned to an area that has either the 24HR processing enabled or
the area is armed.
Disabled the zone can be bypassed while it is in an armed condition. This
option is not recommended unless it is required for a specific reason.
Option 3 - Zone Uses EOL Resistors
Enabled the zone will use the 2 EOL resistor wiring configuration.
Disabled the zone will use no EOL resistors.
Option 4, 5, 6, 7 and 8 - Reserved
Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
Zone Reporting Id
The Zone Reporting Id allows the installer to program any reporting number to any zone. This
provides an extremely high level of flexibility to assign true reporting numbers to the zones. A
zone that is assigned the same reporting ID as another zone will result in both the zones
reporting that ID.
If a zone is assigned an ID number that is higher than the maximum number that can be
reported by a particular service, the service will use the maximum number that can be
assigned for that format.
CP001:01 Report
id: 00000
Protégé Integrated System Controller Reference Manual
124