PRT CTRL Integrated Controller Reference Manual

ZONE INPUTS
Introduction
To access the zone programming, login using the valid installer code and then select [MENU,
4, 2, 1] for zone programming, [MENU, 4, 2, 2] for trouble zone programming and [MENU,
4, 2, 3] for zone type programming. The Zones menu enables you to set up and program all
the zones in your system.
MENU 4, 2
ZONE
PROGRAMMING
MENU 4, 2, 1
ZONE
PROGRAMMING
MENU 4, 2, 2
TROUBLE ZONE
PROGRAMMING
MENU 4, 2, 3
ZONE TYPE
PROGRAMMING
Zone
Figure 7 - Zone Inputs Menu Overview
Zones and trouble zones can only be programmed when the areas they are assigned
to and the area’s 24hr processing are disarmed/disabled, refer to the Arm and
Disarm Operations on Page 33. If the area or the associated 24hr processing is
armed/enabled, you can only view the screens, but not modify the information they
contain. A warning will be shown on entering the zone programming indicating that
the zone is only able to be viewed and the records are locked.
When selecting a Zone or Trouble Zone the zone address is entered using the Module Type,
Module Address and the number of the zone or trouble zone, this is called Protégé Object
Notation. Information on the Protégé Object Notation and how it applies to programmable
objects within the Protégé System refer to the Object Notation Section on Page 402.
For the alarm memory to display a trouble zone when a tamper/short occurs, the 24hr
processing must be enabled for at least one of the area's that the zone has been assigned in.
To access the Zone programming menu login using a valid installer code and then select
[MENU, 4, 2, 1]. The screen displays “Select zone to modify” as shown in the following
example.
Select zone to
modify: CP001:01
121 Protégé Integrated System Controller Reference Manual