PRT CTRL Integrated Controller Reference Manual

For UL and cUL listed installations you MUST set the polling time to 180 seconds or
less.
Analog Expander Module Options
Options that relate to the Analog expander module can be set using option entry.
AE001 Module
[--------]
To modify the module options, use the keypad as explained in section Entering Data Options
on Page 409.
Option 1 – Invert Module Tamper
Enabled the analog expander will invert the module tamper input allowing a
normally open (door closed) tamper switch to be used.
Disabled the analog expander will use the standard normally closed (door
closed) tamper switch.
Option 2 – Virtual Module
Enabled a physical module can’t register at this address. This is used to
protect Zones, PGM’s etc that are used by functions.
Disabled modules can register as normal.
Option 3, 4, 5, 6, 7 and 8 - Reserved
Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
Analog Expander Channel 1 Options
The channel one options configures the first channel on the Analog Expander. Please not that
the settings may not relate to the particular device connected. Some options relate to the
PRT-DAC4 Analog Output Expander and others to PRT-ADC4 Analog Input Expander.
The channel options require a module init or module init with reboot to take affect
with the exception of the Log Channel Data Option 7, which is a controller based
configuration setting.
AE001 Ch 1 Opts
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 – Enable Channel Operation
Enabled the analog expansion device will process messages according to the
options configuration and module type.
Disabled the channel will perform no function.
Protégé Integrated System Controller Reference Manual
118