PRT CTRL Integrated Controller Reference Manual

Enabled the PX16 will activate the relays when they go offline.
Disabled the PX16’s will deactivate the relays when they go offline.
Option 4 - 8 - Reserved
Reserved.
Reserved.
Reader Port 2 Function PGM
You can assign a PGM or PGM group that is used by the multiple badge options.
RD001 R2 Func
pgm: --000:00
To modify the PGM or PGM Group, use the settings as explained in section Entering PGM and
PGM Groups on Page 410.
Reader Communication Failure Card Reading Operation
When the reader expander fails to communicate with the system controller it will default to
allowing access through the controlled doors based on the offline communication failure
configuration and the type of module that has been registered at the reader location. An
intelligent reader expander device will always process users based on the internal offline
database and the configuration settings have no affect unless the No Cards option is selected.
RD001 Offline
All Cards
Option
No Cards
All Cards
First Ten
Site Code
Function
Setting no cards will prevent ANY access from a card reader in the event
the module fails and goes offline. This is also applicable to the PRT-RDI2
and PRT-RDE2 modules.
This will allow ANY card to enter a reader on the PRT-RDM2 and PRT-
RDS2 however on the PRT-RDI2 and PRT-RDE2 only cards that have the
correct access credentials according to the internal database at the
module will be allowed access.
This will allow UN00001 to UN00010 to have unlimited access to the
reader inputs on the PRT-RDM2 and PRT-RDS2 however on the PRT-
RDI2 and PRT-RDE2 only cards that have the correct access credentials
according to the internal database at the module will be allowed access.
During the operation of the PRT-RDM2 and PRT-RDS2 the application
will store the site codes of cards that have been granted access to the
door, the site code will be cached for a period of 7 days or until the card
is denied access normally. Setting this option will allow ANY card with
the same site code to access the readers on the PRT-RDM2 and PRT-
RDI2 modules. The PRT-RDI2 and PRT-RDE2 only cards that have the
correct access credentials according to the internal database at the
module will be allowed access.
Use the [1] and [3] keys to scroll the available offline communication settings. For more
information about the list control data entry refer to the section List Control Data Entry on
Page 406.
115 Protégé Integrated System Controller Reference Manual