PRT CTRL Integrated Controller Reference Manual

Use the [1] and [3] keys to scroll the available arming operation settings. For more
information about the list control data entry refer to the section List Control Data Entry on
Page 406.
Mode
None
Arm on 2 Reads
Arm on Card Read and
Zone Input 8
Arm on 3 Reads
Toggle Function PGM
Activate Function PGM
Operation
No action will be taken by the system for arming an area
associated with the door.
Two successive reads from the same user will result in the
inside or outside area (depending on the card reader type
configuration) starting the arming process.
Pressing and holding Zone Input 8 (RDXXX:08) while
presenting a card will begin arming. Zone 8 must be in an
area that is armed to ensure the zone information is
transmitted to the system controller. The area armed will
depend on the card reader type setting.
Three successive reads from the same user will result in the
inside or outside area (depending on the card reader type
configuration) starting the arming process.
Three successive reads from the same user will result in the
function PGM state being toggled. If the PGM is currently
on it will be turned off and if it is off it will be turned on.
Three successive reads from the same user will result in the
function PGM state being turned on
Reader Port 2 Reader Options
Options that relate to the control of reader functions.
RD001 R2 Option
[123-5---]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 - Reader On Unlock and Door Open
Enabled the reader expander will send card information to the system
controller when a door is unlocked or opened. This option is set by default
and should be left set if the door controls areas or time and attendance
events are required from the reader port
Disabled the reader performs no action when a card is presented and the
door is unlock or open.
Option 2 - Send Door Monitoring Events
Enabled the reader will send door events when the door input is opened or
closed. This is enabled by default but should be disabled on at least one
reader port if both reader ports are controlling the same door (ENTRY and
EXIT access control).
Disabled the reader expander will not send any door events.
Option 3 - LED Follow Lock Status
109 Protégé Integrated System Controller Reference Manual