PRT CTRL Integrated Controller Reference Manual

Use the [1] and [3] keys to scroll the available reader type settings. For more information
about the list control data entry refer to the section List Control Data Entry on Page 406.
Arming Mode
ENTRY Reader
EXIT Reader
Operation
The reader is located on the outside of the door and is used
to enter in to the area that is being protected by the door.
This is the default setting and should be set for all general
access doors (single reader)
The reader is located on the inside of the door and is used
to exit out of the area that is being protected by the door.
If the reader expander is configured for multiplex
reader mode the multiplexed reader is ALWAYS the
EXIT reader.
Reader Port 2 Keypad Operation Mode
The keypad operation mode programmed for the reader on port two determines if the reader
port has a pin entry device attached or uses a local LCD keypad.
RD001 R2 Key Mod
None
Use the [1] and [3] keys to scroll the available keypad mode settings. For more information
about the list control data entry refer to the section List Control Data Entry on Page 406.
When a Wiegand 26 Bit Keypad is used PIN numbers that are prefixed with a 0 can
not be used and the maximum pin number is limited to 65533. This is a limitation of
the 26 Bit Format and not the Reader Expander. To utilize the full 8 digit capacity for
the PIN number of a user and allow prefixed PIN numbers select a PIN device that
supports the ARK-501 or 4 Bit Output Formats.
Reader Port 2 LCD Keypad
If the keypad operation mode is set to use one of the selected LCD keypads you can program
the address of the keypad to use for pin entry. When using this mode of operation the LCD
keypad will present a login message when a valid card is presented that requires pin entry.
RD001 R2 Keypad
None
Use the [1] and [3] keys to scroll the available keypad mode settings. For more information
about the list control data entry refer to the section List Control Data Entry on Page 406.
Reader Port 2 Multi Badge Operation
The reader port can perform various operations when a user badges their card multiple times.
The list below details the modes this can operate in.
When a multi badge operation has taken place the reader expander will beep the buzzer
output four times. In area control, if the area is already armed the reader will only beep
twice.
RD001 R2 Badge
None
Protégé Integrated System Controller Reference Manual
108