PRT CTRL Integrated Controller Reference Manual

Disabled the reader will silently discard any format error. The format error
will still be indicated on the reader input data LED.
Option 8 - Intelligent Reader Tamper
Enabled the reader expander will assume that the external device has smart
messaging that allows a communication path to be formed from the reading
device (Card Reader) to the reader expander.
This allows the reader expander to monitor the reading device and
generate a reader missing alarm (Trouble Zone) if it fails to
communicate with the reader expander allowing the failure to be
reported to a monitoring station. For more information refer to the
Nano Prox Programming Manual.
Disabled the intelligent reader mode is disabled.
It is recommended not to enable/disable or modify the settings of reserved options.
Reader Port 1 Miscellaneous Options
Options that relate to the miscellaneous reader functions.
RD001 R1 Misc
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 - Disarm Area
Enabled the reader process will disarm the area designated by the reader
type (ENTRY or EXIT) and the door configuration programmed (If it has an
area on the inside or outside assigned).
If this option is enabled and the reader is only used for area control then
the area disarmed will be the area assigned in the area control setting.
Disabled the reader will not perform any disarm functions.
Option 2 - Allow User Access if Area Armed
When the option is enabled the user will be granted access based on the
access control configuration only and the area status will not be checked
against the user’s ability to disarm the area.
When the option is disabled and the user who is attempting access to a door
that has an area assigned that is armed and the user can not disarm the
area the user will be denied entry to the door even though they may have
the correct door and schedule settings.
Option 3 - Disarm User Area
Enabled the reader will disarm the user's area when access is granted to the
door they are attempting to access. The users area must still be available in
the user area group assigned to the users access level.
101 Protégé Integrated System Controller Reference Manual