IQ Quick Programming Guide V3.604 - Security Help Desk
IQ Quick Programming Guide V3.604 - Security Help Desk
IQ Quick Programming Guide V3.604 - Security Help Desk
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
p22 Version 3.604 (31/03/05)<br />
INNER RANGE <strong>IQ</strong> PLUS. <strong>Quick</strong> Programmer’s Manual.<br />
30. PROGRAM THE USERS (Wireless Remote Key + Card) cont.<br />
3) User PIN number (if required, must be entered if a Remote or Card is not used)<br />
Enter the new PIN number ... (4 or 6 digits), then press .<br />
4) Press the Area number/s for each Area to be Assigned to this User (0=All Areas De-selected), then press .<br />
5) Select the new User Type number , then press . See table below.<br />
0 Arm Only. 1 Patrol. Arm / Disarm only after an alarm.<br />
2 Arm / Disarm. 3 Defer Arm Only. 4 Toggle User Auxiliary A<br />
5 Toggle User Auxiliary B 6 Arm / Disarm / Isolate. 7 Master.<br />
8 Access Only 9 Access Without Disarm<br />
Delete a User.<br />
1) Key in your PIN, then Select the User Number. Press , , , .<br />
2) Press then .<br />
NO<br />
▼<br />
Move on to<br />
Go to Step 31<br />
Step 34<br />
REX Button on Terminal.<br />
Change<br />
Installer<br />
PIN.<br />
▼<br />
Are the Access Control Options<br />
REX, Door Forced, DOTL used?<br />
YES<br />
▼