Quickview 300 Product Manual PATA - Seagate
Quickview 300 Product Manual PATA - Seagate
Quickview 300 Product Manual PATA - Seagate
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Installation<br />
Figure 3-7 Mounting Screw Clearance for the Maxtor <strong>Quickview</strong> <strong>300</strong> Hard Disk Drives<br />
CAUTION:<br />
The PCB is very close to the mounting holes. Do not exceed<br />
the specified length for the mounting screws. The<br />
specified screw length allows full use of the mounting hole<br />
threads, while avoiding damaging or placing unwanted stress<br />
on the PCB. Figure 3-7 specifies the minimum clearance between<br />
the PCB and the screws in the mounting holes. To<br />
avoid stripping the mounting hole threads, the maximum<br />
torque applied to the screws must not exceed 8 inch-pounds.<br />
A maximum screw length of 0.25 inches may be used.<br />
<strong>Quickview</strong> <strong>300</strong> 80/100/120/160/200/250/<strong>300</strong>GB <strong>PATA</strong> 3-13
Change language