Quickview 300 Product Manual PATA - Seagate
Quickview 300 Product Manual PATA - Seagate
Quickview 300 Product Manual PATA - Seagate
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Installation<br />
3.5 Mounting<br />
3.5.1 Orientation<br />
The mounting holes on the <strong>Quickview</strong> <strong>300</strong> 80/100/120/160/200/250/<br />
<strong>300</strong>GB <strong>PATA</strong> hard disk drives allow the drive to be mounted in any<br />
orientation. Figure 3-7 and Figure 3-6 show the location of the three<br />
mounting holes on each side of the drive. The drive can also be mounted<br />
using the four mounting hole locations on the PCB side of the drive.<br />
Note: It is highly recommended that the drive is hard mounted<br />
on to the chassis of the system being used for general<br />
operation, as well as for test purposes. Failure to hard<br />
mount the drive can result in erroneous errors during<br />
testing.<br />
Drives can be mounted in any orientation. Normal position<br />
is with the PCB facing down.<br />
All dimensions are in millimeters. For mounting, #6-32 UNC screws are<br />
recommended.<br />
Figure 3-6 Mounting Dimensions for the Maxtor <strong>Quickview</strong> <strong>300</strong> Hard Drives<br />
3-12 <strong>Quickview</strong> <strong>300</strong> 80/100/120/160/200/250/<strong>300</strong>GB <strong>PATA</strong>
Change language