Quickview 300 Product Manual PATA - Seagate

More documents

Recommendations

Info

Introduction • MB/s • MHz • ms • MSB • mV • ns • PATA • PC • SPS • tpi • µs •V megabytes per second megahertz milliseconds most significant bit millivolts nanoseconds Parallel ATA Personal Computer Shock Protection System tracks per inch microseconds volts The typographical and naming conventions used in this manual are listed below. Conventions that are unique to a specific table appear in the notes that follow that table. Typographical Conventions: • Names of Bits: Bit names are presented in initial capitals. An example is the Host Software Reset bit. • Commands: Interface commands are listed in all capitals. An example is WRITE DMA. • Register Names: Registers are given in this manual with initial capitals. An example is the Alternate Status Register. • Parameters: Parameters are given as initial capitals when spelled out, and are given as all capitals when abbreviated. Examples are Prefetch Enable (PE), and Cache Enable (CE). • Hexadecimal Notation: The hexadecimal notation is given in 9-point subscript form. An example is 30 H . • Signal Negation: A signal name that is defined as active low is listed with a minus sign following the signal. An example is RD–. • Messages: A message that is sent from the drive to the host is listed in all capitals. An example is ILLEGAL COMMAND. Quickview 300 80/100/120/160/200/250/300GB PATA 1-3
Introduction Naming Conventions: 1.5 REFERENCES • Host: In general, the system in which the drive resides is referred to as the host. For additional information about the ATA interface, refer to the latest revision of the draft standard on the internet at http://www.t13.org/ using the link under “1410D AT Attachment - 6 with Packet Interface (ATA/ATAPI - 6)and (ATA/ATAPI -7).” 1-4 Quickview 300 80/100/120/160/200/250/300GB PATA
Page 1 and 2: Maxtor ® Quickview 300 80/100/120/
Page 3 and 4: Maxtor reserves the right to make c
Page 5 and 6: Table of Content Chapter 1 Introduc
Page 7 and 8: Table of Contents Appendix A BREAKI
Page 9 and 10: List of Tables Table 3-1 AT Jumper
Page 11: Introduction 1.3 MANUAL ORGANIZATIO
Page 15 and 16: General Description •Emulation of
Page 17 and 18: Chapter 3 INSTALLATION This chapter
Page 19 and 20: Installation Figure 3-2 Quickview 3
Page 21 and 22: Installation The configuration of t
Page 23 and 24: Installation 3.3.1.4 Power On Stand
Page 25 and 26: Installation 3.3.2 PATA BUS ADAPTER
Page 27 and 28: Installation 3.4.1 DC Power (J1, Se
Page 29 and 30: Installation Figure 3-7 Mounting Sc
Page 31 and 32: Installation 3.6.1.1 Connecting the
Page 33 and 34: Chapter 4 PRODUCT SPECIFICATIONS 4.
Page 35 and 36: Product Specifications MODELS 80GB
Page 37 and 38: Product Specifications 4.6 Power Mo
Page 39 and 40: Product Specifications Baseplate Te
Page 41 and 42: Product Specifications 4.10 Reliabi
Page 43 and 44: Chapter 5 ATA BUS INTERFACE AND ATA
Page 45 and 46: ATA Bus Interface and ATA Commands
Page 59 and 60: Chapter 6 SERVICE AND SUPPORT 6.1 P
Page 61 and 62: Breaking the 137GB Storage Barrier
Page 63 and 64:
Breaking the 137GB Storage Barrier
Page 65 and 66:
GLOSSARY A ACCESS - (v) Read, write
Page 67 and 68:
Glossary DISK CONTROLLER - A plug-i
Page 69 and 70:
Glossary K KILOBYTE (Kb) - A unit o
Page 71 and 72:
Glossary REMOVABLE DISK - Generally
Page 73:
INDEX A abbreviations 1-1 adapter b
show all

Quickview 300 Product Manual PATA - Seagate

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?