Maxtor OneTouch II Drive - Seagate
Maxtor OneTouch II Drive - Seagate
Maxtor OneTouch II Drive - Seagate
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Adding Rubber Feet to Your<br />
<strong>Maxtor</strong> <strong>OneTouch</strong> <strong>II</strong> <strong>Drive</strong><br />
If you plan to use your drive on a desk surface, your kit includes<br />
four rubber feet to protect your drive and the surface of your desk.<br />
To apply the feet:<br />
1. Make sure your drive is disconnected properly from your<br />
computer. (“Connecting and Disconnecting the <strong>Drive</strong>”<br />
on page 27).<br />
2. Make sure your drive is turned off, by turning off the<br />
power switch on the back of the drive.<br />
3<br />
Rubber Feet<br />
Placement<br />
3. Turn your drive so that the ridges are facing up. This is<br />
the bottom of the drive.<br />
4. Place two rubber feet on each ridge on the bottom of<br />
your drive. One should be placed near the front and the<br />
other toward the back of each ridge.<br />
Bottom of <strong>Drive</strong><br />
Figure 15. Adding Rubber Feet to Your <strong>Drive</strong><br />
Using Your <strong>Drive</strong> 51