Vulkan Lokring MGLD.3000 Product Manual - Schoonover, Inc.

More documents

Recommendations

Info

Multi Gas Leak Detector <strong>MGLD.3000</strong> Operating instructions Environment and selectivity setting Menu entries Warnings / functions Select reference leak and start calibration procedure Check and calibration results Environment setting Device ready to operate Probe active unlocked Connected to power socket Battery charge status Setting the environment This dialog is used to configure the environmental function for all leak search modes. The following selection can be made: • Exterior areas (outdoors) • Hall (large air flow, e.g. from open doors) • Room (small air flow, e.g. from air-conditioners) • Lab (no air flow) The transfer functions "Outdoor", "Hall", and "Room" are only suitable for a quick leak search. For a quantitative determination of leakage level, only the "lab" transfer function is recommended. Setting the selectivity By touching and moving the slider, the selectivity in each direction is changed: • Minimum selectivity: Low selectivity in polluted environments • Maximum selectivity: high selectivity low-effected environments in The selectivity adjustment is only in the refrigerant-probe effec OK - Confirmation, apply the settings and return to the preceding existing leak detection mode. Cancel and reset to original value BAL_MGLD3000_20101001_en.doc 36-54
Multi Gas Leak Detector <strong>MGLD.3000</strong> Operating instructions 4.3.5. Settings Settings Menu entries Warnings / functions Limit value for analysis mode Settings for multipoint mode Volume setting for alarm signal Gas type and leakage unit setting Language setting, date- and time setting Device ready to operate Probe active unlocked Connected to power socket Battery charge status Settings - limit value for analysis mode Menu entries Warnings / functions Limit value for analysis mode Settings for multipoint mode Volume setting for alarm signal Gas type and leakage unit setting Language setting, dateand time setting Device ready to operate Probe active unlocked Connected to power socket Battery charge status This dialogue allows you to enter the limit value for the analysis mode as a numeric value. The currently configured limit value is indicated in the currently selected unit (concentration or leak rate). To change the value, enter the change using the numeric keypad. Entry, e.g. 10.5 Delete the previous character Confirm, accept entry, and return to analysis mode After entering or changing the limit value, the diagram is rescaled in the diagram. Cancel and reset to original value BAL_MGLD3000_20101001_en.doc 37-54
Page 1 and 2: MGLD.3000 OPERATING INSTRUCTIONS 01
Page 3 and 4: Multi Gas Leak Detector MGLD.3000 O
Page 35: Multi Gas Leak Detector MGLD.3000 O
Page 55: Multi Gas Leak Detector MGLD.3000 O

Vulkan Lokring MGLD.3000 Product Manual - Schoonover, Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?