Vulkan Lokring MGLD.3000 Product Manual - Schoonover, Inc.
Vulkan Lokring MGLD.3000 Product Manual - Schoonover, Inc.
Vulkan Lokring MGLD.3000 Product Manual - Schoonover, Inc.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Multi Gas Leak Detector <strong>MGLD.3000</strong><br />
Operating instructions<br />
• When the last test sequence is finished: Start of the next test sequence<br />
• Verlassen des Mehrpunktmodus: „Zurück“<br />
A multi-point leak detection could be stopped by pressing the "BREAK"<br />
ended and the multi-point mode is been able to leave.<br />
After leaving the multi-point mode, all leak detection modes are available on<br />
the menu selection to call or set changes.<br />
For each test series, a log is created that is stored in the device or on memory<br />
stick. The print of a test report for example as a label is optionally possible.<br />
4.3.4. Check + calibration<br />
Check + calibration Menu entries Warnings / functions<br />
Select reference leak<br />
and start calibration<br />
procedure<br />
Check and calibration<br />
results<br />
Environment setting<br />
Device ready to operate<br />
Probe active<br />
unlocked<br />
Connected to power socket<br />
Battery charge status<br />
While using the hand probe the sensitivity of the gas sensors being used can<br />
change, even while being used properly (e.g. because of impurities).<br />
To compensate for these changes in sensitivity, a function is provided for testing<br />
the sensitivity on reference leaks and for setting a gas correction factor.<br />
BAL_MGLD3000_20101001_en.doc 30-54
Change language