CRYSTALSIX - Schoonover, Inc.

More documents

Recommendations

Info

CrystalSix Sensor Operating Manual 2 In similar fashion, connect the Pneumatic Actuator for the source shutter if required. 3 Connect the oscillator cable to the appropriate channel of the sensor board programmed. 4 Connect the source one or source two cable (whichever has been programmed) to the source controller. Figure 2-7 Relay outputs: typical connector configuration utilizing relay #1 NOTE: Contact arrangements shown are of pin mating face (plug or receptacle). The socket mating face is a mirror image of Figure 2-7. IPN 074-155G 2 - 16
CrystalSix Sensor Operating Manual 2.7 CrystalSix Sensor Requirement When Not Installed With An IC/5, XTC/2, XTC/C, IC/4, or IC/4 PLUS The CrystalSix can be manually operated with other Deposition Controllers. The user must, however, be aware of the functional requirements for operation. These include, but are not limited to: 1 The solenoid assembly must be energized and de-energized twice per crystal position. Twelve pulses complete one revolution. 2 The electrical pulse applied to the solenoid valve must be at least one second in duration during both the pressurization and de-pressurization phase. 3 A 24 volt AC or DC supply is required to energize the solenoid assembly. Consult Figure 3-1 on page 3-3 for wiring assignments. 4 The user should provide some means of determining the quantity of “good” crystals when initially loaded, and quantity of good crystals remaining at any time. 5 Follow the guidelines shown in section 2.3 on page 2-7 for installation. 6 You will need to keep track of the total thickness as a manually generated sum of the deposit accumulated on each crystal. IPN 074-155G 2 - 17
Page 1: O P E R A T I N G M A N U A L CRYST
Page 4 and 5: Trademarks The trademarks of the pr
Page 6 and 7: BUSINESS REPLY MAIL FIRST CLASS PER
Page 9 and 10: CrystalSix Sensor Operating Manual
Page 11 and 12: 1.1 Specifications for CrystalSix S
Page 31: CrystalSix Sensor Operating Manual
Page 37 and 38: 3.3 Electrical and Pneumatic Connec
Page 53 and 54: 4.6 Replacing the Bellows Assembly

CRYSTALSIX - Schoonover, Inc.

Create successful ePaper yourself

Delete template?

Save as template?