PTR 225 / PTR 225 S PTR 237 - Schoonover, Inc.
PTR 225 / PTR 225 S PTR 237 - Schoonover, Inc.
PTR 225 / PTR 225 S PTR 237 - Schoonover, Inc.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
2.2 Electrical Connection<br />
The supply voltage and the high voltage switching signal<br />
as well as the measurement voltage signal are carried<br />
through the 8-way FCC 68 socket.<br />
The pinout is given in Fig. 2.<br />
Pin Signal Designation<br />
on the rear<br />
————————————————————————<br />
Pin 1 Supply voltage<br />
14.5 V to 36 V DC + 24 V DC<br />
Pin 2 0 V supply; used as the ground<br />
reference for the supply and<br />
control signal voltages.<br />
COMMON<br />
Pin 3 Pressure dependant logarithmic<br />
signal output<br />
SIGN 0 - 10 V<br />
Pin 4 „PM transmitter“ identification<br />
code (100 kΩ)<br />
IDENT<br />
Pin 5 Signal ground<br />
(use only for the<br />
pressure signal)<br />
SIGN COM<br />
Pin 6 Status (ready to measure) STATUS<br />
Pin 7 High tension „ON / OFF“<br />
(control input); Low active HV ON (L)<br />
Pin 8 High tension „ON / OFF“<br />
(control input); High active HV ON (H)<br />
Note<br />
Signal ground (Pin 5) and power supply ground (Pin 2)<br />
are internally linked. For this also refer to the block diagram<br />
of Fig. 3.<br />
Two examples of how to connect the <strong>PTR</strong> <strong>225</strong>,<br />
<strong>PTR</strong> <strong>225</strong> S or <strong>PTR</strong> <strong>237</strong> are given in Annex 2.<br />
Pin 1<br />
Fig. 2 Connection socket<br />
10 GA 09.308/4.02 - 05/97<br />
10
Change language