IDEC / Datasensor Sensors - Clearwater Technologies, Inc.

More documents

Recommendations

Info

Sensors Fiber Optic: SA1C-FK Dimensions (mm) Panel Mounting Bracket (attachment) Not required for DIN Rail mounting Mounting Hole Layout Receiver Emitter ø4.4 x 2m holes Specifications SA1C-FK3 SA1C-FK3G Light Source Element Red LED √ – Green LED – √ Sensing Distance Depends on the fiber unit (see page 173) √ √ Power Voltage 12 to 24V DC (Operating voltage: 10 to 30V DC) ripple 10% maximum √ √ Current Draw 80mA maximum √ √ Analog Current Output 4 to 20mA, 5V DC maximum 1 √ √ Digital Output NPN open collector 30V DC, 100mA maximum,1.5V maximum with short circuit protection √ √ Operation Mode Dark ON (connect MODE line to GND line) Light ON (connect MODE line to power line) √ √ Response 0.5ms maximum 2 √ √ Indicator Operation LED: Red, Stable LED: Green √ √ Detectable Object Translucent object, opaque object √ √ Hysteresis 20% maximum (using reflex fiber unit) √ √ Sensitivity 4-turn adjustment √ √ Operation Point Control 1 turn √ √ Receiver Element Photo diode √ √ Operating Temperature –25 to +55˚C (performance will be adversely affected if the sensor becomes coated with ice) √ √ Storage Temperature –30 to +70˚C (performance will be adversely affected if the sensor becomes coated with ice) √ √ Operating Humidity 35 to 85% RH (avoid condensation) √ √ Extraneous Light Immunity Sunlight: 10,000 lux maximum; Incandescent light: 3,000 lux (at the receiver) √ √ Noise Resistance Normal mode: 500V (50ns to 1μs, 100Hz: Using a noise simulator) Common mode: 300V (50ns to 1μs, 100Hz: Using a noise simulator) √ √ Insulation Resistance Between live and dead parts: 20MΩ minimum, with 500V DC megger √ √ Dielectric Strength Between live and dead parts: 1,000V, 1 minute √ √ Vibration Resistance Damage limits: 10 to 55Hz; Single amplitude: 0.75mm 20 cycles in each of 3 axes √ √ Shock Resistance Damage limits: 500 m/sec 2 10 cycles in each of 3 axes √ √ Degree of Protection IP66—IEC Pub 529 √ √ Cable Cable type: Ø4.4mm 5-core vinyl cabtyre cable 0.2mm2, 6’–6-3/4” (2m) long √ √ Material Housing: PBT √ √ Accessories Mounting bracket, adjusting screwdriver, load resistor (249Ω) for converting analog amperage to voltage (1 to 5V) √ √ Interference Prevention Up to 2 units can be installed in close proximity. For analog output, interference prevention is not possible. √ √ Weight Approximately 75g √ √ 1. Analog current output specification is based on the power voltage range from 12 to 24V DC (±10%). Use the attached resistor (249Ω, 1/4W) as a load resistance for converting analog output to voltage. 2. Response time for analog current output is between 10% and 90% of the rise or fall of the voltage signal when using a 249Ω resistor. (when using a panel mounting bracket) PLCs Operator Interfaces Automation Software Power Supplies Sensors Communication & Networking Clearwater Tech - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.clrwtr.com - Email: info@clrwtr.com165
Fiber Optic: SA1C-FK Sensors Part Numbers Function Light Source Element Output Part Number Red LED SA1C-FK3 PLCs Green LED Analog output + NPN output SA1C-FK3G For information on accessories, see page 171. Function is determined by the fiber optic unit used. Applications Communication & Networking Sensors Power Supplies Automation Software Operator Interfaces 166 Clearwater Tech - Phone: 800.894.0412 - Fax: 208.368.0415 www.idec.com- Web: www.clrwtr.com - Email: info@clrwtr.com
Page 1 and 2: Automation & Sensing Sensors W For
Page 3 and 4: Sensors Selection Guide Optic Funct
Page 5 and 6: Sensors Selection Guide Application
Page 7 and 8: Tubular: S51 Series Sensors Retro-r
Page 9 and 10: Tubular: S51 Series Sensors Operati
Page 11 and 12: Compact: S60 Series Sensors Through
Page 13 and 14: Compact: S60 Series Sensors Polariz
Page 15 and 16: Compact: S60 Series Sensors Coaxial
Page 17 and 18: Compact: S60 Series Sensors Diffuse
Page 19 and 20: Compact: S60 Series Sensors Long Di
Page 21 and 22: 50 Compact: S60 Series Sensors PLCs
Page 23 and 24: Compact: S62 Series Sensors Compact
Page 25 and 26: Compact: S62 Series Sensors Emissio
Page 27 and 28: Compact: S62 Series Sensors Detecti
Page 29 and 30: Compact: S62 Series Sensors Laser P
Page 31 and 32: Miniature: SA1E Sensors Miniature P
Page 33 and 34: Miniature: SA1E Sensors Detection D
Page 35 and 36: Miniature: SA1E Sensors Specificati
Page 37: Fiber Optic: SA1C-FK Sensors Fiber
Page 41 and 42: Fiber Optic: SA1C-F Sensors Dimensi
Page 43 and 44: Fiber Optic: SA1C-F Sensors Part Nu
Page 45 and 46: Accessories Sensors PLCs Brackets A
Page 47 and 48: Accessories Sensors Through-Beam Fi
Page 49 and 50: Accessories Sensors Dimensions (mm)
Page 51 and 52: Accessories Sensors Brackets Dimens
Page 53 and 54: Accessories Sensors 95ACC1380 (mode
Page 55 and 56: 30º 20º 2 8 5 2 8 Accessories Sen
Page 57 and 58: Accessories Sensors PLCs Operator I
Page 59 and 60: Accessories Sensors Diffuse-Reflect
Page 61 and 62: Color: S65-V Sensors Application Se
Page 63 and 64: Color: S65-V Sensors Specifications
Page 65 and 66: Color: SA1J/SA1J-F Sensors Color: S
Page 67 and 68: Color: SA1J/SA1J-F Sensors PLCs Ope
Page 69 and 70: Color: SA1J/SA1J-F Sensors Power Su
Page 71 and 72: Contrast: TL46 Sensors Contrast: TL
Page 73 and 74: Contrast: TL46 Sensors Specificatio
Page 75 and 76: Luminescence: LD46 Sensors Luminesc
Page 77 and 78: Luminescence: LD46 Sensors Specific
Page 79 and 80: Fork/Slot: SR21 Sensors Fork/Slot:
Page 81 and 82: Fork/Slot: SR21 Sensors Power Suppl
Page 83 and 84: Distance: S80 Sensors PLCs Laser di
Page 85 and 86: Distance: S80 Sensors Detection Dia
Page 87 and 88: Distance: SA1D Sensors PLCs Operato
Page 89 and 90:
Distance: MX1C Sensors Distance: MX
Page 91 and 92:
Distance: MX1C Sensors Part Numbers
Page 93 and 94:
Area: AS1 Sensors Area: AS1 High-re
Page 95 and 96:
Area: AS1 Sensors PLCs Operator Int
Page 97 and 98:
Area: DS1 Sensors Area: DS1 Detecti
Page 99 and 100:
Area: DS1 Sensors PLCs Operator Int
Page 101 and 102:
Magnetic: DPRI Sensors PLCs Operato
Page 103 and 104:
30º 20º Accessories Sensors 95ACC
Page 105 and 106:
Laser Safety Sensors Laser Safety I
Page 107 and 108:
General Information Sensors Communi
Page 109 and 110:
General Information Sensors Sensors
show all

IDEC / Datasensor Sensors - Clearwater Technologies, Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?