common - Sanyo Denki America, Inc.

5. Type R Interface
Command Code2216h Data Length19bytes
Input and Output Port Function
DAT No Function Setting range Initial value(hex) Setting unit
DAT1 Input logic 0 Other than SELECT 0 On
selection
Active
SELECT0Point 1PRG
DAT2 Output logic 0 conn.On Active
selection
conn.
DAT310 Input Port 015h 8,0,1,2,3,4,D,15
function
DAT11 Output Port 029h 0,1,2,3,4,D,28,29,E
19 function
Sets the input / output signal logic of CN1, and selects the function of the generic input / output signals.
DATA NO Function Bit7 Bit6 Bit5 Bit4 Bit3 Bit2 Bit1 Bit0
DAT1 Input logic SEL STOP HL- HL+
DAT2 Output logic ZONE ALM
DAT3 Input function Allocates functions to each CN1 input PortIN1IN8.
10
Functions are to be selected from Chart 1.
DAT11
19
Output function Allocates functions to each CN1 output PortOut1Out9.
Functions are to be selected from Chart 2.
Points can be selected up to maximum of 128, but PEND output can be selected only up to 64
Points.
When either of Out8 or 9 is selected for the encoder signal output, both Out 8 and 9 will be encoder
output. The selected function remain valid for other cases.
530