common - Sanyo Denki America, Inc.

Pulse Train Input Interface
Command settingShown below is a setting example of Command 17.
Set the commands such as a soft switch, input and output function if necessary
Double click on Command 17
Set the motor TYPE, pulse input method and resolution and then click on the SET button.
Must be set as damage may occur to both motor and amplifier when the motor Type is not
appropriate.
Transfer data to amplifier by pressing the SEND button.
Press PC→Amp ROM on the MENU button and Save the sent parameter to the non-volatile memory.
Press Save as the transferred data will not be saved until this is done.
When it is saved on the Amplifier, it needs to be saved only once after setting parameters
as all commands will be forwarded and saved at once.
If necessary, follow the same procedure as to set parameters other than Command 17
(11h).
441