common - Sanyo Denki America, Inc.

More documents

Recommendations

Info

4. Pulse Train Input Interface Abbreviation Display Alarm cause RGOL The PB amplifier regulates the regeneration voltage by software control and detects regeneration error when the stipulated value is exceeded. Regeneration to the power source is prevented within the amplifier. Contact Sanyo Denki for assistance if regeneration control is not sufficient. When excessive regeneration voltage occurs, the hardware might be damaged. When used with abrupt deceleration or under excessive load, gradually accelerate and decelerate starting from low-velocity operation to check the drive. Confirm the rated load limit for each motor before operation. Refer to Chapter 6 for more information about load limit. ORG Indicates a zero-return error. For C-phase detection zero-return Indicates that the C-phase could not be detected within one rotation of the motor shaft For SDN detection, Push zero-return Indicates that the drive was incomplete within the travel distance range set by command 23h. Wrap Around Indicates the overflow of absolute position counter. Command 14h-DAT4-Bit1 can be used to enable or disable detection of this condition. Not detected on the initial value. LAE Indicates a count error of the encoder counter. Detected only during the motor operation. Confirm that there is no sensor error caused by shock to the motor or excessive noise. OC Indicates excess current in the motor. It does not function as protection for short circuit or earth-fault on the power line. Contact Sanyo Denki for assistance if problem occurs. EEPER Indicates a non-volatile memory data error. After detecting the memory error, the parameters are reset to the initial factory settings. Contact Sanyo Denki for assistance if problem occurs. 435
4. Pulse Train Input Interface 4.4.3 Alarm Recovery Process There are recoverable alarms and unrecoverable alarms (Refer to Section 4.4.1) depending on the alarm cause. When the alarm occurs, remove the alarm cause to cancel. For recoverable alarm Will be cancelled by ALMCLR signal. 300ms min ALM output Motor drive ALM CLR 4ms min For unrecoverable alarm It is necessary to reconnect the power. Remove the alarm cause and reconnect the power. 436
Page 1 and 2:
M0007846 SANMOTION CLOSED LOOP STEP
Page 3 and 4:
Contents 1. Safety Pre
Page 5 and 6: Safety Precautions common 1.1 Int
Page 7 and 8: Safety Precautions common 1.3 Safet
Page 9 and 10: Safety Precautions common Operati
Page 11 and 12: 2. Model Number Specifications (com
Page 13 and 14: 2. Model Number Specifications (com
Page 15 and 16: D5 6 7 8 9 A B C 3. Installation /
Page 17 and 18: 3. Installation / Wiring (common)
Page 23 and 24: Pulse Train Input Interface
Page 33 and 34: 4. Pulse Train Input Interface
Page 55: 4. Pulse Train Input Interface
Page 65 and 66: 5. Type R Interface
Page 107 and 108:
5. Type R Interface
Page 109 and 110:
5. Type R Interface
Page 111 and 112:
5. Type R Interface
Page 113 and 114:
5. Type R Interface
Page 115 and 116:
5. Type R Interface
Page 117 and 118:
5. Type R Interface
Page 119 and 120:
5. Type R Interface
Page 121 and 122:
5. Type R Interface
Page 123 and 124:
5. Type R Interface
Page 125 and 126:
5. Type R interface
Page 127 and 128:
5. Type R interface
Page 129 and 130:
5. Type R Interface
Page 131 and 132:
5. Type R Interface
Page 133 and 134:
5. Type R Interface
Page 135 and 136:
5. Type R Interface 5.8 Comm
Page 137 and 138:
5. Type R Interface 2 Status
Page 139 and 140:
5. Type R Interface 2Communi
Page 141 and 142:
5. Type R Interface 5.8.7 Co
Page 143 and 144:
6Specifications (common)
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
6. Basic Specificationscommon
Page 151 and 152:
5 6 7 8 9 A BCD E F 0 1 2 3 4 6. Ba
Page 153 and 154:
6. Basic Specificationscommon
Page 155 and 156:
7. Options 7. O
Page 157 and 158:
7. Options 7.2.3
Page 159 and 160:
7. Options 7.3 O
Page 161 and 162:
8. International Standards Conformi
show all

common - Sanyo Denki America, Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?