Instructions for use I - Hofmann Megaplan
Instructions for use I - Hofmann Megaplan
Instructions for use I - Hofmann Megaplan
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
5.2.1.2 - ALU-M WHEEL<br />
(correction from inside <strong>for</strong> two balancing planes with direct calibration):<br />
Fig. 10<br />
After measurement <strong>for</strong> inside F1 as shown in Þ g. 10, again remove the gauge in order to memorize<br />
the data <strong>for</strong> the outside FE;<br />
N.B.: once in position, always push the gauge upwards and keep it <strong>for</strong> at least 2 seconds.<br />
Manual presetting is possible by using the push buttons as follows.<br />
5.2.2 - MANUAL PRESETTING (Use only in special cases or <strong>for</strong> checking)<br />
- Standard wheel<br />
Fig. 11<br />
- Press until a symbol is read out<br />
- With gauge in rest position, measure the distance, in cm, of the<br />
machine wheel. Set the value substracting 1.5 cm.<br />
- Select by pressing<br />
- Set the nominal diameter indicated on the tyre.<br />
- Select by pressing<br />
- Set the nominal width, which is normally stamped on the rim, or<br />
proceed to measure the width with the caliper gauge (supplied as<br />
standard).<br />
I 0162 GB - 11