AGFA d-lab.3 Digital Compact Lab

General Data and Informations
Repair
Densitometer
Calibration Automatic prior to every measurement to D=0,10 (Y, M, C)
Data rate 1.200 Baud: Print mode / factory-set
(Jumper 1 and 2 not set)
9.600 Baud: Test mode
Interfaces
Connector 3 (data interface acc. to RS232)
Type: Sub-D 9 poles
Jumper settings Jumper position Mode Baud rate
Normal 1.200
Machine selection
Measuring characteristics
Transport speed
Normal: The Jumpers have no impact
on the densitometer function in this
position
Do not set! Only for the assembly !
Densitometer may get damaged
1.200
Selection by means of soldering bridge Br1:
Br1 open
When Br1 is open, the transport speed can be selected with Br2
Measuring range
Reflection D=0,00 to 2,55 (minus the basic density)
Measuring accuracy under the particular climatic conditions
− Linearity, reproducibility:
- to density 1,30 ± D=0,01
- to density 2,00 ± D=0,02
- to density 2,55 ± D=0,03
Selection by means of soldering bridge Br2 (Br1 must be open):
Br2 short-circuited V = 1.400 mm/min d-lab.3 Process
—
10.6 2000-01-02 /PN 9009 AGFA d-lab.3