AGFA d-lab.3 Digital Compact Lab

Repair
Maintenance
Paper Processor
Whole Machine
− Clean all chains, gears and bearings and grease
them with Klübersynth
Processing Racks
Clean the racks and check them for smooth
movement (25-60 Ncm)
On all racks including the squeegee unit over
the STB3 rack:
Check the gears, roller shafts, slide bearings
and springs for damage / wear and replace
them if necessary
Check the position of the slide bearings: The
nipple points to the inside (see figure)
− Two squeeze rollers are the most critical points
in all racks (see arrows in figure above). The
stress is the strongest in the CD racks because
they are very close to the liquid level:
− Check the backlash of the squeeze rollers
with AGFA Prestige paper or similar
− If necessary, replace the bottom rollers
(P3-E5146) and the squeeze rollers
(P3-86682)
− Replace all sponge rubber rollers for STB in the
squeegee area
− Clean the bearing points and remove the crystals
in this area
− To protect the dry running bearing points (above
the liquid level) from the penetration of chemistry
(crystals) and keep the rack torque small
at the same time, the chemical-resistant
Klüberplex (sealing grease) is recommended:
Apply an evenly thin film on the shaft bearing
points (take out the bearings and grease the inside).
roll_02
AGFA d-lab.3 2001-01-02 /PN 9009 9.7