AGFA d-lab.3 Digital Compact Lab

Printer
Repair
Lane Distributor LD, replacing Parts
− Pull the lane distributor to the front on the
telescopic rails
− If required (for some components), dismount the
lane distributor:
− Screw 4 bolts into the lane distributor from
below so that it can be deposited correctly
− Lift the lane distributor off the telescopic rails
dlabr039
Replacing the Motors LD_MO01 to LD_MO05
Replacement required:
Motor defective
LD_MO01: Drive takeover section LD
LD_MO02 Drive sheet distribution vertical
LD_MO03 Drive sheet distribution horizontal
LD_MO04 Drive exit station, 2 lanes
LD_MO05 Drive back printer
Position MO01 to MO04: See Fig. on the next page
Allan key 3
Dynamometer
Service cables L9.8060.9001.1 and L9.8060.9002.1
Removal:
− Disconnect the motor connecting cables
− Unscrew the motors 01, 02, 04;
Slacken motor 03 first: Open the two belt
tensioners on the opposite side
− Remove the sync disk (circlip)
Installation:
− Mount the sync disk on the new motor
− Mount the new motor
− Connect the cables
6.4.54 2001-01-02 /PN 9009 AGFA d-lab.3