AGFA d-lab.3 Digital Compact Lab

Printer
Repair
Replacing the Set of Belts at the bottom
Replacement required:
Belts or rollers damaged by a paper jam
Allan keys 3 and 4
Screwdriver
Spanners 13 and 9
Removal:
− Pull out the PE
− Open the set of belts
− Remove the locking lever on the left side:
Remove the safety spring (1)
− Remove the sensor holder (2) with sensor
PE_LS02
− Detach the spring (3) on the actuator
− Open the circlip (4) on the toggle, push in
actuator piston
− Remove the toggle (5)
− Dismount the sensor PE_GS03 (6) with the
holder
− Unscrew the Allan screws (7) (key size 13) on
both sides of the cast frame:
The set of belts only hangs on 1 supporting screw
(8) on either side
− Remove the supporting screw on the right side,
only slacken it on the left side until the set of belts
is free
− Remove the set of belts
dlabr289
Installation:
− Put the new set of belts in the supporting screws
first, tighten the screws
− Mount 2 Allan screws on either side
− Check the belt mounting position
− Mount sensor PE_GS03
− Mount the toggle:
Do not unscrew the eccentric screw (lacquersealed,
specific gap dimension)!
− Mount the sensor holder with sensor PE_LS02
− Hang in the spring
− Mount the locking lever
− Close the set of belts
dlabr290
6.4.40 2001-01-02 /PN 9009 AGFA d-lab.3