AGFA d-lab.3 Digital Compact Lab

Repair
Printer
Replacing the Gearing
Replacement required:
Leaking oil, synchronisation problems caused by the
gearing
Allan keys 2,5 and 3 and 4
if available, a second person to help
Removal:
− Pull out the PE
− Unscrew the rear plate with the venting slits on
the exposure slit
− Open the bottom set of belts
− Open the fastening of the gear coupling for the
print roller: 2 Allan screws
− Close the bottom set of belts again
− Disconnect the motor cable (in the top frame) and
remove the motor
− Unscrew 3 fastening screws (vibration absorbing)
outside the gearing
− Remove the gearing with the motor plate and the
motor PE_MO02
Call a second person to help: If the gearing slips out
of its bearing with the roller, the RH bearing of the
roller may get damaged (loss of the accurate
running properties).
The closed belt bridge supports the print roller only
to a limited extent.
dlabr099
1 Motor PE_MO02: Drive feed and exit roller PE
2 Gearing
− On the gearing side, open the fastening of the
clutch for the motor MO02 (in dismounted
condition)
− Remove the motor plate with the motor from the
gearing: 3 x vibration absorbers
Installation:
− Link the new gearing with the motor, fasten the
clutch
− Mount the complete unit, carefully insert the roller
drive shaft and lock it with screws
− Screw down 3 screws of the suspension points
until the sleeves in the rubber buffers feel
resistance
AGFA d-lab.3 2001-01-02 /PN 9009 6.4.35