AGFA d-lab.3 Digital Compact Lab

Printer
Repair
Replacing the Motor PE_MO02
Replacement required:
Motor defective
Allan keys 1,5 and 3
Screwdriver
Removal:
− Pull out the PE
− Disconnect the cable of MO02 (at the bottom;
brown)
− Disconnect the sensor cable from PE_LS04
− Unscrew the Allan screw 1,5 on the motor side of
the clutch
− Remove the motor plate with the motor and the
sensor from the vibration absorbers:
Unscrew 3 Allan screws
− Detach the motor from the motor plate:
4 slotted countersunk head screws
Installation:
1 Motor PE_MO02: Drive feed and exit roller PE
2 Gearing
dlabr099
− Change the motor
− Mount the motor plate:
Mind the location of the vibration absorbers and
the clutch; screw in the screws tight up to the
stop (sleeve and rubber buffer)
− Connect the motor and sensor cables
Adjustment:
Test the function in the Service program
6.4.34 2001-01-02 /PN 9009 AGFA d-lab.3