AGFA d-lab.3 Digital Compact Lab

Printer
Repair
Replacing the Turntable
Replacement required:
In case of damage
The turntable must be replaced together with the
turntable shaft as the parts are lacquer-sealed!
Allan key 3,0
Seeger circlip ring pliers
Removal:
− Pull out the TU
− Unlock the bottom unit and fold it down
− Unscrew the cover of the printed circuit and
disconnect all cables to drive unit 1:
ST 6, 9, 10, 17, 21, 22, 23, 25
− Tilt away the complete printed circuit with the
carrier plate; unscrew 2 screws
− Unscrew drive unit 1 and remove it towards
the bottom: 5 screws (1) at the front, 3 screws
at the back
− Open the Seeger circlip ring and strip off the sync
disk with the toothed belt
Installation:
Make sure that the assembly group is put exactly in
the recesses when mounted, otherwise no correct
paper transport can be guaranteed.
1 Fastening screw (1st of 5 front)
dlabr213
Check the toothed belt tension
6.4.32 2001-01-02 /PN 9009 AGFA d-lab.3